DIY: Simple Chain Link Necklace

May 11, 2013
Simple necklaces are an essential in my wardrobe. I have so many elaborate tops that a simple necklace is key to finishing an outfit. Here is how to make this simple chain link necklace, the possibilities are endless with this.
What you need:
Curb link chain
Small chain
Jump rings
Lobster clasp
1. Figure out how long you want the curb link chain to be. I just put the chain up to my neck and measured out enough so that the large chain is only showing in the front when I wear it.
2. Cut two pieces of small chain, one slightly longer than the other.
3. Attach a jump ring to one end of the smaller chain, put it through the last curb link chain and attach it to itself. It will create a loop around the curb link.
4. Attach the other small chain and lobster clasp, then you’re done!
It’s very simple, yet can finish an outfit off.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.